Helmholz CAN Bus Connector

The article 700-690-1BB12 is a CAN bus connector that connects directly to the CAN bus interface (9-pin SUB-D socket) of the participants. The CAN bus cables are connected using 6-pin screw terminals. A slide switch allows you to set whether the connector should be used as a node or at the segment end. The switch can also be operated when installed, and the setting is clearly visible. In node mode ("OFF"), the connector should be used when the incoming and outgoing bus are connected to each other. The terminating resistor is then ineffective. As a segment end ("ON"), the connector should be set on the first and last participants of the segment. In this case, the terminating resistor is connected on the incoming bus, and the outgoing bus is disconnected. The CAN connectors also operate in an extended ambient temperature range from -25 °C to +85 °C. Additional participants can be connected via the additional connection jack.

Available in 3 configurations:

• CAN Bus Connector 90°, with additional connection jack
• CAN Bus Connector 90°, without additional connection jack
• CAN Bus Connector axial

For more information, download the attached flyers.